I noticed while lubing/seating GC some would not seat uniform. I could easily inspect the gap from top of GC to where the profile changes on the shank of boolit. This is actually the first time using this boolit. I culled any out when casted that did not have nice sharp profile of the boolit.RCBS Lubasizer
.311" sizer die
Gator GC's
311165 NOE boolit dropping at .311-.312"
for got what lube, but was purchased from Vendor on here....its kind of light pink colorALSO something i have never questioned after a dozen i start to have a build up of lube on the top of die. I usually just scrape it off. Is this normal? How can i prevent?
Also with the above happening i am getting lube on bottom of GC. Will this have any effect on performance as i'm sure some powder will stick to the lube?
thanks
DWD
Sunday, April 28, 2013
inconsistent/crooked seating GC
Labels:
inconsistentcrooked,
seating
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment