The other trick is to take the guide rod on the Lee trim gauge and using a rough scrubbing pad clean the rod, it might have crud buildup from other cases that have been trimmed.
Just a suggestion.
Jim
Tuesday, December 24, 2013
Can someone?
Do not lower the die, just lower the decaping rod a little, you may not have it down enough. The way to check is to bring up a LUBED case into the full length resizing die, then loosen the nut on the rod. Let the rod stop at the bottom of the case and re-tighten the nut on the rod. lower your ram and measure again.
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment