Monday, April 15, 2013

new lee six cavity mold

Cast Boolits - Dedicated To The World Of Cast Bullets!

horsemen61 is online now Boolit Mold Join DateOct 2012Posts5

Ok guys here is the deal I just ordered and got a lee six cavity 148 grain dewc .358 mold for my 357. ? TIME how do I get it ready to make BOOLITS.
Clean it with solvent or soap n water. I used a dremel buffing wheel w/ jewlers rouge on my cavities & then clean it again. Drops boolits now without issues. Been using 2 cycle on spruce plate n pins. Someone with more experience may have other ideas.
Please don't use a Dremel tool inside the cavities of your new Lee mold.

That aluminum is awfully soft.

If you have problems with bullets sticking and not falling out freely, there are other ways of taking care of this other than using a Dremel tool.

Ben

This sub-forum has many stickies on the subject.
You may not post new threadsYou may not post repliesYou may not post attachmentsYou may not edit your postsForum Rules

Abbreviations used in Reloading
Pointed Soft Point "Core Lokt"


View the original article here

0 comments:

Post a Comment